Replacement Parts for Older Equipment

When a part for older equipment is worn, broken or no longer made, we scan it, model it and make new ones, with or without a drawing.

A laser scans a cast pump housing into a point cloud, the points become a triangle mesh, then a clean CAD model that is checked against the scan.

A machine that still runs well can be stopped by one part that is no longer made. Nielsen Enterprises makes replacements for parts like that, even when there is no drawing and the original maker is long gone.

How it works

  1. Send us the part. A worn or broken part is often enough. If you have a drawing or a model, send that too.
  2. We scan and model it. Using laser scanners, structured light, CMMs or industrial CT, we capture the part and build an accurate CAD model from the scan. See Laser Scanning and Reverse Engineering.
  3. We make it. Machined from solid, or cast from new foundry tooling when the original was a casting.
  4. You keep the model. The next time you need the part, the drawing exists.

How many?

One part, a few spares for the shelf, or a short run of up to 50. The setup that makes the first part makes the rest, so the spares match.

Have a part in your hand? Start a quote request with a few photos and its rough size, or bring it by our shop at 3075 Spruce Street in Little Canada.

Common questions

Do I need a drawing to get a replacement part made?

No. Send us the worn or broken part and we scan it and build the CAD model. A drawing or model helps if you have one.

Can you make just one replacement part?

Yes. One part, a few spares or a short run of up to 50. The same setup makes every part, so the spares match.

Have a part, a drawing or a sketch?

Tell us what you need made. Quotes are free.